1990 Jeep Cherokee 4.0 w/ 5 speed
And I mean ALL parts, from the pedal rubber to the clutch itself.
Thanks!
clutch, pressure plate, throw-out bearing, pilot bearing, slave cylinder, clutch master cylinder, clutch rod, rod dust boot, hydraulic lines, pedal mounting bracket, pedal return spring, spring bushings, pedal, and last pedal pad
so any help would be nice. thank you for anyone that has an opinion.
Would go for a Valeo Kit
I have a 2000 Civic Si with a bad Clutch that needs to be replaced. I don’t have the money to put something like what i had(ACT Stage 2 Clutch) in right now, so I looking to get one of these kits to get me by for now. My budget is $200…but I’m also going to resurface the flywheel. Thanks… http://www.importrp.com/product.php?productid=61161&cat=0&page=1
They’re fabulous Juan…
I want to buy a 1984 chevy k20 pick up with a 4 speed in it. The owner says the clutch springs need to be replaced what all needs to be done for me to change them. I have a lot of knowledge with chevy trucks so i think i can do this, also how much will this cost.
Doing this yourself can save you allot of money. I believe it can be done for under 300 dollars. Be sure you use a disk alignment tool when you tighten the bolts of the pressure plate to make the reassembly much easier. Also you can slide the tranny back resting the front on a floor jack rather than removing it. Just remove the crossmember bolts from the frame and leave the rear transmission mount connected. Should be plenty of room. Scratch that you said k-20 the transfer case will most likely be in the way.
The engine/transmission was put in about a month ago, along with a new clutch. The car has only been driven 4-5 days. The clutch suddenly started making chirping noises when pushed, and the gears were difficult to shift into. The clutch cable constantly needs to be adjusted.
take it back to the shop where you had the work done. the clutch needs to be properly adjusted, and/or the clutch cable replaced, and and/or the throw-out fork is cracked and needs to be replaced. many things could cause these issues. your auto service provider can tell you whats going on.
I am looking for cluth parts manufacturer for Massy Ferguson and Fiat tractor .
If you can provide with the Material Specs,Engineering drawing
and pertinent trade terms, we can contract to your custom requirements and supply the same: <IAAI-Gyantec@lycos.com>
Contact with your representative profile & quarterly requirements
and time frame and the legal/draft of the contract.
- – - – - – - – - – - – - – - – - – - – - – - – - – - – - – - – - – - – - – - – - – - – - –
Question: What are the different Clutch tractor mechanisms of MF & FIAT that has since been adopted by both the Companies over the last 2 decades.
